Texture of zirconia obtained by forced hydrolysis of ZrOCl2 solutions

The structure and surface properties of ZrO₂ strongly depend on its preparation. In the present work the impact of prolonged aging at basic conditions (pH = 9, T = 100°C, t = 48 h), on the phase composition and textural properties, obtained by calcination of the precipitate, was investigated using several techniques conjointly (DTA/TG, DSC, XRD, porosimetry). The thermal effects accompanying the ZrO₂·xH₂O gel formation, the coalescence of the particles and crystallization were evaluated and discussed in terms of the structural differences between the aged and non-aged samples. This revised version was published online in July 2006 with corrections to the Cover Date.     

Influence of Some Aggressive Media on Corrosion Resistance of Mortars With Spent Cracking Catalyst

The influence of spent catalyst from catalytic cracking in fluidized bed on the hydration process of cement and the properties of cement mortars were studied. The spent catalyst was used as an additive to cement in the mortars (10 and 20% of cement). The samples of mortars kept in water for28 days, then they were placed in sulfate and chloride media for 2 months (the control samples were kept in water for 3 months). After this time they were subjected to bending strength and compressive strength determinations. Thermogravimetric and infrared absorption studies were performed and capillary elevation, capability of binding heavy metals, and changes in mass and apparent density were determined too. The studies disclosed the pozzolana nature of spent catalyst and its influence on cement mortars being in contact with corrosive media. This revised version was published online in August 2006 with corrections to the Cover Date.     

主动冷却点阵夹层防热结构温度响应计算模型北大核心CSCD

针对点阵夹层结构主动热防护问题,建立了夹层结构面板和芯体导热与冷却剂对流耦合的非稳态传热理论模型,利用有限体积法离散控制方程并在MATLAB中进行了迭代求解.模型首次考虑了面板与夹芯杆之间的收缩热阻,并利用分离变量法得到了收缩热阻的近似解析解.基于单胞模型和周期性边界条件,模拟得到了模型所需的表面对流传热系数h_(b)和h_(fin).最后,选取多单胞计算工况进行数值模拟和理论模型对比,并讨论了收缩热阻对模型预测精度的影响.结果表明:理论模型能够准确预测夹层结构及内部流体的温度变化,理论与仿真之间的最大误差不超过1%;随着外加热流密度不断增大,忽略收缩热阻使得计算结果造成的误差不断增大;与数值模拟相比,理论模型可显著地减少计算时间并节省计算资源,尤其适用于非均匀、非稳态复杂热载荷下点阵夹层结构的温度响应计算.     

Normalized Dynamic Characterization and Application of Multiple Heat Storage Materials Based on Standard Thermal Resistance北大核心CSCD

基于标准热阻和能量流法,推导出储热材料与换热流体的瞬态换热热阻,通过类比电路分析法,获得了储热-换热过程的瞬态热量流模型及动态响应时间常数。进一步引入节点温度,重新定义换热热阻,获得了储热与换热过程耦合的三阶电路瞬态热量流模型,求解得到了加热、储热和释热三类时间常数,可用于协同表征储热材料中储热与释热的快慢程度,从而实现了多类储热材料的归一化动态表征。通过数值模拟验证与应用对比分析,发现基于多时间常数的归一化动态模型用于表征储热材料的动态特性是可行的,可直接对不同换热、储热材料进行对比分析。案例分析发现与固体储热材料换热时,液态金属的动态换热能力优于熔融盐,而相比于水蒸气和CO₂,空气与陶瓷材料换热能更快达到稳态。     

Study of the influence of physical aging on macroradical decay in poly(methyl methacrylate)

The macroradical decay in poly(methyl methacrylate) samples with different thermal histories was investigated in the temperature interval 20–100 °C using ESR spectroscopy and the second order kinetic model. The rate constants exhibit two different regimes with the transitions atT _tr=68±1°C which are independent of thermal treatment. ForT<T _tr andT>T _tr the rate constants as well as the corresponding activation parameters are sensitive to history because of different physical microstructures. The compensation law, i.e., the linear relation between lnk _{o, eff} andE _eff, was analyzed in terms of the so-called compensation quantitiesk _c andT _c and a proximity betweenT _c=T _tr andT _o=53±3 °C — Vogel temperature for -segmental dynamics was found. A comparison of kinetic and dynamic data suggests that the decay of terminal macroradicals in the low-temperature region is controlled by secondary relaxations and that the -mobility contributes to a more rapid decay at higher temperatures belowT _g.     

钇提高YT14硬质合金耐磨性的机制

研究了不同Ｙ添加量对ＹＴ１４硬质合金显微组织、结构和耐磨性的影响。结果表明，在ＹＴ１４硬质合金中添加微量Ｙ，可显著提高合金的耐磨性。Ｙ的主要作用是均匀细化碳化物相和Ｃｏ相；提高Ｃｏ粘结相中Ｗ、Ｔｉ元素的固溶量及αＣｏ相所占的体积分数，从而提高Ｃｏ粘结相的强韧性；Ｙ在合金中形成Ｙ２ＷＯ６，表明Ｙ还可还原和清除碳化钨表面氧化膜，增强Ｃｏ粘结相与硬质相之间的结合强度     

Amino acid overproduction by analog resistant mutants of the nitrogen fixing cyanobacteriumAnabaena sp 287

Two amino acid analog resistant mutants of the cyanobacteriumAnabaena sp 287 were isolated after MNNG mutagenesis.Anabaena ST 16, a mutant resistant to the alanine analog D-α-aminobutyric acid andAnabaena ST 25, another mutant resistant to the histidine analog l,2,4-triazole-3-alanine, released alanine and histidine, respectively, into the medium upon immobilization in alginic acid during diazotrophic growth in fluidized bed reactors. The rates of amino acid production by the mutants were 4.3 μmol mg chl^-1 h^-1 of D-alanine byAnabaena ST 16 and 16.6 μnol mg chl^-1 h^-1 of L-histidine byAnabaena ST 25. Nitrogen fixation by the mutants was not affected by the extracellular amino acid concentration. While the radioactive carbon flow was followed, the parent strain retained 93% of fixed¹⁴C and released only 7% into the medium. On the other hand,Anabaena ST 16 released 13% andAnabaena ST 25 released 29% into the medium. These mutants are beneficial in the production of radioactive amino acids using diazotrophic photobiotechnology.     

A DSC study of the effects of sugars on thermal properties of rice starch gels before and after aging

Thermal characterization of gelatinized binary rice starch-water and ternary starch-sugar-water gels before and after aging was carried out using differential scanning calorimetry. The glass transition temperature of the maximally freeze-concentrated solution (T_g) in both fresh and aged gels was observed to decrease progressively with increasing sugar concentration. Aging of the gels generally shiftedT_g to higher temperatures, but had little or no effect on the ice melting peak temperature (T _m). The presence of various sugars could either accelerate or retard starch (amylopectin) recrystallization, depending on the type and concentration of sugar, as well as on starch/water ratio. A hypothesis based on the dual antiplasticizing-plasticizing effects of sugars was postulated to explain the observed effects. Of the sugars studied, xylose and fructose appeared to display exceptional retardative and accelerative effects, respectively, on retrogradation.This study was funded by a Sixth Malaysia Plan R&D grant under the Intensification of Research Priority Areas (IRPA) Program of the Ministry of Science, Technology and Environment, Malaysia. We thank Dr. Harry Levine and Dr. Louise Slade for giving us the opportunity to contribute a paper to this special issue of JTA.     

聚丙烯/纳米级金红石型二氧化钛/聚烯烃弹性体复合材料的抗老化性能研究

采用TEM和UV-Vis等测试手段表征了金红石型纳米级TiO2和体相TiO2的性能特征;通过熔融共混法分别制备了PP/纳米级TiO2/POE和PP/体相TiO2/POE复合材料,采用GB/T16422·2-1999所述的塑料实验室光源暴露实验方法,用氙灯气候试验机对纯PP和复合材料进行28天人工加速老化.结果表明,二氧化钛粒子在PP/POE基体中分散性良好,而纳米粒子对PP/POE基体具有增韧作用;改性后的两类复合材料均具有优异的抗老化性能,而PP/(1·0wt%)纳米级TiO2/POE复合材料的抗老化性能更加优异,其加速老化28天后的无缺口冲击强度达到80·45kJ·m-2,比纯PP提高4倍多,而同期加速老化28天后的PP/(1·0wt%)体相TiO2/POE复合材料的无缺口冲击强度只有47·88kJ·m-2;对纯PP老化过程中的羰基指数和冲击性能的变化情况进行了分析,发现二者近似成线性关系,其相关系数r在0·9以上.